IHSH-62-IND - 12oz Wabash Western Shirt - Indigo
-
@Eza in general measurements in the IH shop are to be trusted. The ones in this thread could be from an older batch.
I would go for your usual size. Worst case, IH wabash tolerates a 90C wash very well and you will then shrink it at least one cm in all directions.
-
this will be my first IH shirt. will this shrink with every soak/wash? I plan to wear this mostly unbuttoned, over a shirt, like a jacket almost. So I'm not sure if I should go with my normal size L or size down to an M. Aware that the measurements chart is there but yeah, also worried the L could be too big.
-
@vince If you think the measurement would work with a medium i would go with that. You will get a little shrink but not much and it will stretch back out. also, the body length on these is pretty long so I bet you'll enjoy the length of the medium better.
I wear an xl in all Iron heart shirts, including this, but the 62 is only shirt I bet I could size down to a large in.
-
@vince Great choice indeed! If you have a shirt that fits similarly to what you are looking for with this one, go by the measurements
Shrinkage is almost negligible. But to second the others, this is one of the very shirts where I sized down from my regular XXL to XL and still have enough room. -
Thank you guys for the advice here!!
-
Same as above comments with sizing. Went with my same size for most other shirts, but had a little extra room (which I don't mind on my westerns).
I've also washed and tumble dried this shirt so many times without worry and it comes out great. The tail in the back curls up a bit (just from the way it's constructed) but other than that it has stayed pretty consistent. I just do the normal inside out, presoak, was cold, tumble dry low. Easy and is breaking in nicely!
-
Love this thing
-
I had a chance to see this fabric in person at SE PDX recently. Prior, I dismissed it on some incorrect assumptions. The blue is deep and the bleach dots are a super interesting detail. So I went out and found one from another stockist. SE was out of my size.
A large should show up next week and I’m anxious to see how it fits. I know these can run big and I tend to be a Large or XL, depending on the fabrics. Stoked!
-
@Bobcat-Sig Love this fabric!
Personally I would love to see it without the wabash dots as well, as in straight up indigo or black. "The undotted".
-
I'm so bummed! I ordered what I thought was an in-stock shirt from Iron Shop Provisions. Turns out, it was an error on their part, and the shirt wasn't in stock. Major bummer. Especially when I was holding out for this shirt instead of the turquoise check shirt that just dropped. But I digress...
However, they do have a medium in stock. I know some of you here rolled the dice with a size smaller than your usual IH shirting. I'm a tag L in most western cuts, save for the selvage flannel and vintage black denim, where I went tag XL. Do I roll the dice and go tag M on this shirt?
-
@Bobcat-Sig This shirt does fit a little larger than my other IH mediums, but maybe not a full size down. It seems mostly bigger around in the waist and sleeves, but not so much in the chest and shoulder width.
-
@indigo_fades Good to know. I did not exercise patience and opted for the medium. Channeling my Iron Heart sizing by measurement (and not tag), all measurables seem to be right in the sweet spot, save for the shoulder, which was about an inch to half an inch shorter than usual. YOLO amirite?
We'll see how it fits when it shows up.
-
The shirt arrived yesterday. My first purchase with Iron Shop Provisions, and they were great. I sized down, looking at the measurements, and it seems to fit well... save for the pits. I usually focus on the chest/pit-ot-pit measurement, as that usually ensures I have enough around the body there to make it work, and while this particular shirt measures out well there, the shoulder measurement is a little shorter than normal when looking at other shirts.
I know fit can be a personal preference and that measurements don't always tell the story. How much tightness, if at all, do you tolerate? Or is it a sign of pit tightness that the shirt is sized incorrectly?
-
@Bobcat-Sig this shirt is gonna get some shrink when you wash it...something to be aware of.
-
@Mizmazzle I was hoping you wouldn't say that.
I almost always wash these shirts in cold water, gentle cycle, no spin, and line dry. Is shrinkage expected, even with that level of care?Safety third
-
@Bobcat-Sig that’s how I’ve ways washed mine too. I recall it coming in maybe 1/2” in shoulder and maybe a touch more in the chest. Wish I had some measurement data for ya. Thought I might have posted my initial wash info back in the thread a few years back.
