IH-888S-UHR - 21/23oz Ultra Heavy Raw Selvedge Denim High Rise Tapered Cut Jeans
-
-
Got done with a hot soak of about 45 minutes and washed them on the "warm" setting with no spin.
Wife asked what was washing in the machine. I stated "just some jeans". Her reply: "Are you washing ALL of them", when I told her it was just two pairs she rolled her eyes. I hung them to dry in the downstairs shower to dry overnight.
I hung them out on the porch this morning so they could dry in the sun, and when I got home from work, I tried both pairs on.
Fucking PERFECT fits.
I'd like to extend a "Thank you" to all of you who have contributed good info over the years as to how to properly size these and account for shrinkage.
-
-
@Blue-Viking This is the recommendation for UHR fabric:
The UHR is loomstate. No processes have been performed on it. This means that the constructional stitching is not embedded into the fabric and can pop out. In addition the fabric is so dry and stiff that creases will be very sharp and abrasive and can tear.
Soaking AND an initial wash are necessary to embed the stitching and finesse the fabric. Shrinking is a by product of this.
Hot soak and wash to embed the stitches and failure to follow those instructions can lead to premature failures.
“…hope that somewhere there's a hobbit with a ring on his way to a volcano.” - Nic
-
-
@Blue-Viking none. I can’t stand wearing wet denim…they really need to be shrunk to embed the stitches. They will be tight for a day, two, or maybe a few, but stretch back out with time and wear. You will gain the most in the waist, a little in the thighs, but everything lost in the length is gone.
-
@Blue-Viking , if they fit and are comfortable now, they'll stretch back out to the pre shrink/wash sizing.
-
Hey guys! Question for those who've got a lot of wears in these and in 888's in general... I have an issue (I think) due my to relatively small waist size compared to my butt/thigh size. Whenever I sit, bend or squat at all, the back of the waist band comes away from my body and traps my shirt in that gap when I stand back up. It also happens when I wear a belt as tight as it can go. Is this something that happens to any of you? And if so, did it go away as the denim broke in and conformed to your body? I've heard this might just be a thing with high rise jeans, so I'm curious what your guys experience has been. Thanks!
-
14 days of wear, creases starting to form and a small amount of fade. Trying to hit at least 10000 steps a day and will continue to wear everyday until I can’t take the heat anymore.
-
The temperature of the water DOES NOT make much difference to shrinkage. Agitation does. The reason a hot wash shrinks stuff more than a cold wash is that a hot wash normally has a longer more aggressive wash-cycle, hence the misunderstanding....
https://forum.ironheart.co.uk/topic/2492/shrinkage-what-is-it?_=1777200490666
-
Is it fair to say agitating unsaforized jeans at home is a way of somewhat sanforizing them? I'm sure not to the same extent the actual process agitates them.
-
@catdad1 said in IH-888S-UHR - 21/23oz Ultra Heavy Raw Selvedge Denim High Rise Tapered Cut Jeans:
Is it fair to say agitating unsaforized jeans at home is a way of somewhat sanforizing them? I'm sure not to the same extent the actual process agitates them.
No, it shrinks them.
Sanforisation is completely different thing.
-
-
Trying to wrap my head around best practices for the initial shrink with these.
Is it best to hot soak and then toss in the washer (inside out)? Or is a soak with hand agitation sufficient?
Also, I’ve seen mention of wearing them to STF. Some neutral opinions on it, some advice to do it if there is concern about shrinking, and some advice not to do it due to it being unnecessary/a hassle and causing knee bags from wearing while wet - is there a consensus?
-
The UHR is loomstate. No processes have been performed on it. This means that the constructional stitching is not embedded into the fabric and can pop out. In addition the fabric is so dry and stiff that creases will be very sharp and abrasive and can tear.
Soaking AND an initial wash are necessary to embed the stitching and finesse the fabric. Shrinking is a by product of this.
Hot soak and wash to embed the stitches and failure to follow those instructions can lead to premature failures.
