Giles and Paula's Great Retirement Adventure
-
Looking sharp....
-
Gorgeous!
-
How often do you have to get it out of the water and do that kind of work?
-
Normally about once a year.
Jet wash to get the crud off, it is amazing what will grab onto and live on the hull and running gear
Wet and dry the rudders and rudder mounts, 5 coats of primer
2 coats of antifoul (paint) to hull and rudders
Wet and dry props and shafts, then coat them in lanolin
Remove and replace sacrificial anodesThis time I am also going to get the topsides (the part of the hull above the water line to the gunwhale) cut and polished. Salt and sun really mess with gelcoat, and once it loses its shine, crud can take hold very quickly
I also have a through hull fitting (the salt water intake for the generator) that is a bit dodge, and you cant fiddle around with one of those if it is in the water, because if it goes pear shaped, the boat will take on water very quickly. So I will dick around with it and if I screw it up, I can safely replace it without sinking the boat.
The shaft seals are also a tad dodgy, and you cant fiddle with them when the boat it in the water (because they also go through the hull below water level).
-
Progress...
Antifouled, most anodes replaced, shaft anodes removed and generator saltwater strainer removed, so I can get the top off and Loctite the hose fitting properly)...
To do; get the top off the strainer, currently sitting in limescale remover, as I think the cap is sealed on with calcium build up. Polish the shafts (there are some benefits) and props, attach new shaft anodes, Lanolin the running gear. And a few other niggly little jobs here and there....Target date for refloat 2nd Dec, but may manage earlier if the weather continues to be kind.
-
did you ever have to go back and fix the radar thing on the roof?



