Repairs & Modifications
-
mending small holes in Tee shirts.
ok bit of a long post sorry but want to make it real clear and simple to follow [hopefully]
do it as soon as you see a small hole and unfortunately its never an invisible fix.here is the hole which is about a 5mm hole
Start by choosing the right thread, i like to use as close as possible to the actual material to the garment
I am in the trade so i happen to have indigo dyed 100% cotton thread in the right shade but if you can get hold of any indigo thread it will do the job as it will fade.
the one on the right is a more the more common colour of indigo thread you can buy which is quite dark like raw denim.
2nd is having the right needle.
any sewing needle will do just a nice fine one. if you got a new needle then bend it like in the picture below
it will make your life a lot easier when hand sewing.
let start sewing!!
we're doing this on the wrong side of the garment [inside out]
for tees only sew on the vertical as going the other way will cause it to fray more.
take a very small stitch, catching just one thread at a time.
start from the side where the hole is at it's smallest.
going in to the hole and coming though the right side of the garment.
now do the same on the bottom of the hole but going though the wrongs side then coming though the hole.
gently pull it tight as you go across the hole. at the end take one more stitch at the base of the tread and loop
a knot, pull though and trim leaving a small 1/8th of an inch tail behind.
and we're done!! like i said unfortunately its never going to be an perfect invisible mend but it will stop the hole from getting bigger, well for now anyway.
-
-
Spent my vacation with an friend who has a few pair.. He wears his Iron Hearts to work. He's worn out the cuff in the shop and had to sew the two halves back together..
Check those Superblacks still dark and an awesome tight weave..
-
That tutorial is much appreciated jimmy! Cheers!
-
That tutorial is much appreciated jimmy! Cheers!
Your welcome. When I get more time I'll go though and do all the common repairs.
-
my good buddy jaco did this for me.
great job imho & so appreciated. the devil's thank you
-
i figured fire & brimstone shouldn't be a problem & took a walk through HELL. . .
guess that boiling lake was a bit much
thanks again to jaco. that's the old patch. would have replaced with a 666 patch but one wasn't available at the moment, & if you know anything about me from the forum i am inpatient as hell.
-
-
hey jimmy, it was a literal boiling soak to make sure i got all shrinkage out of my devil's. the denim & all the hardware besides the patch was fine.
-
I broke the zipper on my Wings and Horns jacket and I was wondering if someone involved in the industry could advise me on how difficult a repair would be. The pull tab on the slider broke off and the first tooth is also loose so the entire zipper would have to be replaced.
I talked to Giles briefly about this at the party and he showed me a tool which can remove the rivits. Would a normal tailor be able to do the replacement? Also, how hard would it be to get new rivits and a new zipper equivalent to the Riri which is currently there.
