Time For a New Jeans Cut….
-
More room in the top block than BB I imagine…
-
I'm quietly hoping the thighs are more akin to the 1955 than the 634
-
All will be revealed…...
-
Right so all I need to do to get the Sherpa lined trucker jacket made is get Giles drunk! Why didn't someone tell me this before!
-
Right so all I need to do to get the Sherpa lined trucker jacket made is get Giles drunk! Why didn't someone tell me this before!
Evidence suggests you may have to be ginger too.
-
I don't want it that bad….
-
It was G's idea, I just provided some input and a sounding board for the constant swearing and abuse
-
Man, I loved that show
-
New jeans cut.
Higher rise than IH-634 - particularly at the back.
More taper from the knee than the 634.
this interests me greatly
-
Great news regarding the new cut. There has been quite an amount of suggestions / wishes for a such cut so I hope it will sell well and offer a lot of denims over time. I would assume the 21oz will be the first run…?
-
@Max:
There has been quite an amount of suggestions / wishes for a such cut so I hope it will sell well and offer a lot of denims over time.
Agreed! Fingers crossed for retailer interest also.
@Max:
I would assume the 21oz will be the first run…?
I hope so. I haven't had indigo 21oz in rotation for over a year and I miss it.
So excited about this.
-
Hope there is enough of a taper left when they get hemmed to say 32-34 leg.
-
- If we want to have selvedge side seams and a proper cut, there is a limit to the taper that can be given to the jean. To have selvedge side seams, the outseam HAS to be parallel, so you have to take the taper off the inseam, take too much and the cut is a joke. One of the reasons that the IH-634 is a better cut in many ways than the IH-634S, is that we don't have to worry about a parallel outseam.
- We could use selvedge denim and dispense with the selvedge ID showing on the outseam (like the IH-461S), but that is probably a compromise too far.