Giles and Paula's Great Retirement Adventure
-
Looking sharp....
-
Gorgeous!
-
How often do you have to get it out of the water and do that kind of work?
-
Normally about once a year.
Jet wash to get the crud off, it is amazing what will grab onto and live on the hull and running gear
Wet and dry the rudders and rudder mounts, 5 coats of primer
2 coats of antifoul (paint) to hull and rudders
Wet and dry props and shafts, then coat them in lanolin
Remove and replace sacrificial anodesThis time I am also going to get the topsides (the part of the hull above the water line to the gunwhale) cut and polished. Salt and sun really mess with gelcoat, and once it loses its shine, crud can take hold very quickly
I also have a through hull fitting (the salt water intake for the generator) that is a bit dodge, and you cant fiddle around with one of those if it is in the water, because if it goes pear shaped, the boat will take on water very quickly. So I will dick around with it and if I screw it up, I can safely replace it without sinking the boat.
The shaft seals are also a tad dodgy, and you cant fiddle with them when the boat it in the water (because they also go through the hull below water level).



