IH-888S-21 - 21oz Selvedge Denim Medium/High Rise Tapered Cut Jeans - Indigo
-
@Aminnix829 July/Aug
-
Back from repair and still going strong. I bought these 1 size too big. I've learned to size down 1 inch in the waist from where you want them to end up. These have also loosened up a lot in the thighs to the knee (even though people say they don't change). My own body measurements thighs etc haven't changed a bit. Maybe just the 21oz. My 21oz sbgs also loosened up a ton. These are super soft and very comfortable now. Great summer jeans! Still going to wear these a lot.
-
Gents, I hope this is the right spot to ask this question - apologies if it isn't, I did spend most of this morning perusing the forum and couldn't find a better spot than this one.
I received a pair of 643s in 21oz (size 31, with the wonderful IH staff having informed me by e-mail in advance that they had a 30.5 waist measurement - Jesus, talk about customer service!) earlier this week and I'm blown away by the quality. I've worn my fair share of raws over the last 20 years, but never experienced anything like the IH fabric.
I'm 100% committed to grabbing a pair of 888s in 21oz when they're restocked (I saw the comment above indicating a provisional July/August timeframe). The only thing I need to figure out now is whether to go for a size 30 or size 31.
The 643s with a 30.5 waist fit me like they were made-to-measure for me. Scrap that: I actually do have several MTM jeans, and none of them fit me as well on the waist as these).
I've also read several comments on this forum of people suggesting to go down one size in the 888s when compared to the 634. Others suggest taking the same size.
Right now I'm leaning towards buying a size 30 and leaving a comment on the order asking to find a pair with a close-to-30.5-waist. Any thoughts or feedback from you more experienced gents? Is there a "golden standard" on ordering a bigger size and asking for a smaller waist from stock, versus ordering a smaller size and asking for a bigger waist from stock?
Thanks everyone, highly appreciate any and all input.
-
@M.EDS You'll need to wait for the sizing chart to be posted, it changes from different releases/restocks... I'm sure you could get a 30.5 like you said if you put a note with your order
-
@M.EDS After about 6 pairs of 888s i can honestly say i regret a little bit sizing down with my early pairs. It's annoying having to stretch them back out after i wash them.
My thighs fill out the 888 pretty well, but the waist is definitely the tightest part of this cut imo. the 1" of stretch they post in the product description is where you should be. I dont try to go for more than that anymore.
My trick for 888 sizing is to measure my own waist around the outside of my underwear's elastic, then get the waist size 0.5" smaller than that. YMMV.
-
@M.EDS Definitely go by the measurements and not the tag size. Also be aware that the 888 has a pretty roomy mid/high rise. It's not a slim fit high rise. It all depends on how you're built. Talking to @WhiskeySandwich before, I'm similar in that my mid-thigh to knee is always the bottleneck with the 888s, not the upper thighs. It's still great, but I go for the smallest waist I can manage to keep the top block from looking bad. As I stated in my other post. The 21oz definitely has give and I've stretched them out in all areas including the entire thigh/knee. I'm a camera operator though and get into all kinds of crazy positions with these jeans. I would say if they are pretty snug but not uncomfortably tight and irritating you're right where you need to be. I second @WhiskeySandwich on the waist sizing.
-
@M.EDS Your type of physique has alot to do with being able to size down from 643 or not. I think for most people same tag size works out pretty good. Now if your waist is alot narrower than your hips and you are ok with leg room being tighter specially closer to the knee you may be able to size down. I personally cannot unless its a run with different measurements than usual. As every said measurements is king. The safe bet will be same tag size.
-
Kind of related to the chat above about sizing, @Jord and @Denimhead-0 you both have 643s and 888s, are your go to waist specs the same? Or for the 643 with a lower rise and sitting on the hips do you go for slightly bigger? ....i am starting to get the 643 itch....but damn i dont need another pair of jeans or pants
@WhiskeySandwich interesting comments. Im still in the camp of like getting things tight but then stretching out and moulding to you (as long as i know the denim can stretch). With the 888s i have gone one size up before and its comfy, but was just cautious not to have that diaper pants look too...
-
@cyclops It really depends on the cut/denim etc, I have a W32 in the 634 and W33 in the 888 in both UHR, I also own a pair of XHS 634 which are a 34 waist...
Always go with the size charts! But I'd say I go slightly bigger on 634, the W32 I have in the UHR is due to the size chart being slightly larger, but we all got different body types etc, I will say the 634 are awesome though
-
@Jord yeah fair enough. But like for me, i typically look for 32.5 inches as my go to. But like for the 666xhs, i found i needed 33inches and more
So just wondered between them you stuck to a similar figure. But it sounds like for the 634 you go a little bit bigger. Which i will have a think....thanks!
-
@cyclops I can get away w .5” less w the higher rise 888.
-
@Denimhead-0 awesome thanks man! This really helps me make an informed decision
