WESCO-MRLOU-BLK - Wesco® - 10" Horsehide Pull-On "Mister Lou" Engineer Boot - Black
-
Thank you gents! I'm going to keep these and hopefully they'll break-in nicely.
-
@bluemantra I recently had the same at first i thought they didn’t fit but after 2 weeks of wear they start to give a little and are getting better by the day
-
-
@bluemantra FWIW I thought my pair was too small for about 6 months before the leather started to stretch and become pliable. Now, the boots are nearly 2 years old and completely different than when they were new. It just takes time and wearing a lot. The heel slip is hardly noticeable now too, while before my foot was all over the place in the boots. Now, I don't think about how they fit because they are molded to my feet.
-
my Mr Lou size 9D have always been good from day one (even though I have a size 8/8.5D) probably the shape adapts to my foot, no slipping of the heel (which for example I found in the 7500 shape E) the only problem was the tip of the big toe on my right foot, (my grandmother always told me to cut my toenails a lot, especially at the corners and from what the beautician told me it was one of the billion mistakes I have done in my life), so I discovered that a very small callus had formed on the inside side on the nail bed and Mr Lou made me walk like rusty Robocop
for months ... then I solved the problem and now they are perfect like a glove even if after a couple of years they are still very rigid (characteristic of vegetable tanned leather) sooner or later they will break, for those who have chosen the Horween CXL version everything will be simpler and faster. Good evening dear friends, sorry if with my broken English I tried to tell the story of my life in a post -
rusty Robocop!
-
Maybe a silly question, but are you supposed to remove the instep buckle when putting on and taking off engineer boots?
WTB IHJ-140-IG size L
-
@bluemantra I only unbuckle mine when cleaning. Slip 'em on and off.
-
@bluemantra it depends on whether you need it to put them on or not, I only started untying the lace when I got to tightening it at the 5th hole, until the 4th I didn't need it, after a few weeks I no longer needed to untie it. Undoubtedly vegetable tanned leather is quite rigid and requires more time for everyone, but it also has extreme elasticity.
-
I never unbuckle them only when i clean them to be honest.
-
@bluemantra Read this on how I wear mine and find as an excellent resource. I know not everyone will agree:
https://nicksboots.com/blog/post/getting-engineer-boots-fitted/
-
Thanks all. I was just concerned because they've been a bit tough to take off and didn't want to stretch the leather, thereby making them looser without the ability to tighten them back up.
-
Also with mine, I used to have the lower buckle on the loosest setting, but over the yearsthe leather stretched and stretched to the point now I am yanking and pulling the strap all the way down to the last hole.
-
@Oaktavia And yours started off tight correct? I've got the insoles out now so that if needed they can be placed back in to tighten the fit up.
-
@bluemantra yeah they were definitely snug when new. They fit like a slipper now.
-
Hi guys, I'm sorry if this specific question has been asked numerous times but I was wondering if anyone here has or have tried on the Red Wing 2966 (soft toe) that was a limited release a few years ago in the US and how those fit compared to the Mr. Lou? I have the Red Wings in a 9.5d but feel I could go a half size up and am considering the Mr. Lou in a 10d as a replacement if I can find a pair. I've read here that they generally run the same size as Red Wings, however Red Wings sizes can vary greatly between models/lasts. IIRC the RW 2966 was slightly narrower than standard red wing fit, which is a good thing for my 10.5C size. The Mr. Lou apparently runs narrow as well so it seems the sizing between the two is similar. Just wondering if anyone here has tried both and can comment on how the fit on each might compare.
-
@Luijim78 said in IHWE-MRLOU-BLK - Wesco
- 10" Horsehide Pull-On "Mister Lou" Engineer Boot - Black:my Mr Lou size 9D have always been good from day one (even though I have a size 8/8.5D) probably the shape adapts to my foot, no slipping of the heel (which for example I found in the 7500 shape E) the only problem was the tip of the big toe on my right foot, (my grandmother always told me to cut my toenails a lot, especially at the corners and from what the beautician told me it was one of the billion mistakes I have done in my life), so I discovered that a very small callus had formed on the inside side on the nail bed and Mr Lou made me walk like rusty Robocop
for months ... then I solved the problem and now they are perfect like a glove even if after a couple of years they are still very rigid (characteristic of vegetable tanned leather) sooner or later they will break, for those who have chosen the Horween CXL version everything will be simpler and faster. Good evening dear friends, sorry if with my broken English I tried to tell the story of my life in a post @Luijim78 are you an 8/8.5D on the brannock, but wear a 9D mister lou?
